Getbig.com: American Bodybuilding, Fitness and Figure

Getbig Bodybuilding Boards => Steroids Info & Hardcore => Topic started by: clayton green on July 15, 2007, 02:28:18 PM

Title: Injection of quads
Post by: clayton green on July 15, 2007, 02:28:18 PM
What is the most one would recommend to inject in quads.  I have only done 1cc thus far but I have read where some have done as much as 3cc's.  I have done 1cc in delts and traps and 3cc in glutes.

I usually use 1" on the thighs and delts and 1 1/2" on glutes.  Can one use a smaller length pin on these sites and still get into the muscles?

I have pinned my quads in the center of the thigh, pinning between about one hand width above the knee and one hand below the top of the thigh.  I also pin on the upper outer thigh and outer middle thigh.

Title: Re: Injection of quads
Post by: JaggyShortBuff on July 15, 2007, 02:47:05 PM
I have only pumped 2cc tops in my quads...3cc in my glutes...I have put 2cc in my delts before too, but I had to leave the needle in for a while longer because it felt like the oil wanted to leak right out of the injection site...
Title: Re: Injection of quads
Post by: Luv2Hurt on July 15, 2007, 03:10:15 PM
Your quads should be (some people this is far from the case, the long shorts crew) one of your biggest muscles.  They will hold 3ml no problem.
Title: Re: Injection of quads
Post by: coolioni on July 15, 2007, 11:48:09 PM
Start with 2 ml, then work up to 3 if you are worried, but plenty of people shoot 3 mls all the time.
It is a pretty large muscle.
I can't shoot there becuase I always seem to hit a nerve , I am scared to stick a needle there at this point.
I got sick of getting that crazy sharp pain when you stick the needle into a nerve.
But, there are plenty of people that know exactly where they can shoot it without any problems!
I used to inject into my biceps and triceps in the past, but now I just do shoulders and glutes only.
I mainly do shoulders becuase I have to hide my cycling from my wife, and she always feels around my butt for lumps when I start looking bigger.
She usually can tell I am on within a few weeks, but now I am on HCG all the time and she thinks I am growing from that.
Sorry I got off topic a bit!
Title: Re: Injection of quads
Post by: Beener on July 16, 2007, 03:01:01 AM
Hah damn thats sneaky dude, good luck  :P
Title: Re: Injection of quads
Post by: Rimbaud on July 16, 2007, 06:22:27 AM
Can one use a smaller length pin on these sites and still get into the muscles?

Maybe if you don't carry a ton of fat there.
Title: Re: Injection of quads
Post by: clayton green on July 16, 2007, 07:16:12 AM
Maybe if you don't carry a ton of fat there.

Rimbaud,

Do you think I could get away with 1/2" or 5/8" on the delts and thighs, neither of which carry much fat?
Title: Re: Injection of quads
Post by: Rimbaud on July 16, 2007, 07:17:47 AM
Rimbaud,

Do you think I could get away with 1/2" or 5/8" on the delts and thighs, neither of which carry much fat?

Maybe but I wouldn't chance it. I'd still stick with a 1" needle for thighs. Maybe it would work for delts - I don't know because I don't hit them at all.
Title: Re: Injection of quads
Post by: BigIronMike25 on July 16, 2007, 01:46:49 PM
I routinely blast the quads with 2 or 3 cc's...and i've never had any problems except mild to moderate soreness for a couple days!
Title: Re: Injection of quads
Post by: trab on July 16, 2007, 02:00:00 PM
Rimbaud,

Do you think I could get away with 1/2" or 5/8" on the delts and thighs, neither of which carry much fat?

I sometimes  use 1/2" &  5/8" 25ga on Quads or delts w/ 1cc max. I measure a 3/8" max pinch of fat on thigh. Delts way less.
Title: Re: Injection of quads
Post by: clayton green on July 16, 2007, 04:57:30 PM
Thanks, I will give the small pins a try on the delts and thighs.  I know that freakfestmd has  said that he uses 1" on his glutes as well.
Title: Re: Injection of quads
Post by: Overload on July 17, 2007, 05:59:55 AM
Minimum 1" on Quads and glutes, you want to inject deep.

i prefer to use 1.5" for Quads and 1" for delts.

i've shot 3cc's in my quads and delts with no problems, i wouldn't recommend 3cc in the delt unless you have some serious delts, i do it all the time though.

8)
Title: Re: Injection of quads
Post by: clayton green on July 17, 2007, 06:56:22 AM
You must have some serious size quads to use 1 1/2".  I hate using the 1 1/2" on my glutes, sometimes it feels like the pin may be coming out the other side.  I do use 1" on my delts, traps and quads.  I guess everyone has their preference.  I just want to make sure the pin goes in far enough.
Title: Re: Injection of quads
Post by: freakfestMD on July 17, 2007, 11:25:00 AM
Thanks, I will give the small pins a try on the delts and thighs.  I know that freakfestmd has  said that he uses 1" on his glutes as well.

1" pins work well for me anywhere.  I have little to no bodyfat.  Besides, and inch of fat is actually quite a lot. If you can't hit a muscle belly, including your ass, with a 1" pin you probably have no business doing AAS in the first place ;D.

My upper outer quads and glutes have seen as much as 5cc at one time with no problem at all.
Title: Re: Injection of quads
Post by: Rimbaud on July 17, 2007, 11:27:05 AM
i've shot 3cc's in my quads and delts with no problems, i wouldn't recommend 3cc in the delt unless you have some serious delts, i do it all the time though.

8)

That's because you're the second largest person in the world.  ;D
Title: Re: Injection of quads
Post by: Rimbaud on July 17, 2007, 11:27:30 AM
I routinely blast the quads with 2 or 3 cc's...and i've never had any problems except mild to moderate soreness for a couple days!

Same here.