Getbig.com: American Bodybuilding, Fitness and Figure
Getbig Bodybuilding Boards => Steroids Info & Hardcore => Topic started by: shrek on June 13, 2009, 03:36:47 PM
-
i went from a 22g 1" to a 25g 5/8" what do yall think as for useing that needle everywhere but glutes is it too shallow for quads
-
as long as you inject into the muscle your fine. I have such a low BF that I could get away with using those but I do not know your body. i use 1in 23 g needles and some time 1.5in 23g (when i do it in the glute). I would use at least 1 inch. But whatever works for you.......
-
Don't like it at all. Stick with the 1" the gear needs do be relatively deep in the muscle. Try a 23G.
-
cool thinks i was iffy on it also they feel great cause there small but i can feel the oil is closer to the surface also it makes a slightly raised area
-
I don't like using small needles since they tend to "move around" too much when injecting. 23 g 1' are good, i used to use 21 g 1,5' not anymore... :)
-
I am pretty lean, and I use an 11/2" pin for glutes and 1" pin for all other places. I completely agree with Luv!
-
The only thing I would use a needle that short for is winny.
-
5/8" is ok for biceps, since your only using one hand. Just bury it to the hub. I'm also with L2H, 23g 1 1/2" for everything else...
-
Don't like it at all. Stick with the 1" the gear needs do be relatively deep in the muscle. Try a 23G.
Agreed, 23 is da bomb!
-
well cant find any 25g 1" or 23g 1" at vet stores is needlebeast my best bet they are pricey compared to local vet store
-
yo ordered syringe with 25g 1" needle and that shit is great hardly any blood and barely feel the prick, downside is , hard to draw so i use an 18g 1.5" to draw the gear and then the smaller one times the flow perfect
-
yo ordered syringe with 25g 1" needle and that shit is great hardly any blood and barely feel the prick, downside is , hard to draw so i use an 18g 1.5" to draw the gear and then the smaller one times the flow perfect
Dont like the 25g for oil injects. Too much moving around of the needle as you struggle to push the plunger down. Have found 23g to be best compromise.
-
i use for winstrol and testo suspension 27G.
for tren 0.5x19....
why use 23g..its too big
-
i use for winstrol and testo suspension 27G.
for tren 0.5x19....
why use 23g..its too big
27G ? never heard of using that but if it works for you. As I said don't like anything under 23G for OIL injects. Sure for water based stuff the 25G would probally be OK cause it flows out easy enough. Although have heard people say sometimes Winny will clog small G needles. i myself have never experienced this.
-
Tthat's all I use for most sites, 25g5/8 and 23g1 for deeper areas.
Fuck that 21g shit, I'm tired of leaving holes in my body.
-
what do you think of 22G x 1, 1/4
0.7x30 mm.
Thanks
-
23G 1.5 for glutes
23G 1" for everything else, I pin quads, delts, pecs, and sometimes front delts