Getbig.com: American Bodybuilding, Fitness and Figure
Getbig Bodybuilding Boards => Steroids Info & Hardcore => Topic started by: Max B on July 22, 2011, 12:47:00 PM
-
alrite friends i have some test p and mast p vials that are crashed but not fully, ive been heating them up and there may be one or two small crystals left in the vial but it always stays at the bottom even when im drawing oil out to shoot.. my question is when im shooting this gear and theres still crystals left in it that literally will not go away, am i still getting the desired hormone im aiming for or am i literally just shooting oil? any help is needed and i know this sounds stupid but let me know. thx
-
if the crystals dont melt then they arent in the oil and your gear is less potent. it might help to vigorously shake the bottle to loosen them up if they are stuck to the glass or something. if not, re heat again. if at sufficient temperature they should melt.
-
Stick it in the oven. Unscrew a pin from one of your syringes. Stick the pin into the vial and put it in the oven and bake. The pin will help the bottle vent so it doesn't explode.
-
lol really what temp? i thought u had to put it in boiling water.
-
lol really what temp? i thought u had to put it in boiling water.
I cant rember the temp. Google. baking gear. Pobally around 350 not positive though. Just make sure you vent it. You could also do the boiling water.
-
baked it with a pin for 20 min at 225 degrees.. it did the trick... some oil did evaporate though i think it was just the BA and not actual hormone though correct?
-
baked it with a pin for 20 min at 225 degrees.. it did the trick... some oil did evaporate though i think it was just the BA and not actual hormone though correct?
Good job you did good. It shouldn't effect the gear at all.
-
is it safe to "rebake" the vial again if a small amount of crystals reappear after a few days/weeks? or does it get to a point where you fuck up your gear?
-
is it safe to "rebake" the vial again if a small amount of crystals reappear after a few days/weeks? or does it get to a point where you fuck up your gear?
as long as you dont let it get too hot then its fine. "too hot", dont quote me on this, and it differs from hormone to hormone, but i think as long as your under 400 degrees or so youll be fine. and all u need to melt the hormone into the oil is ~200 max.