Getbig.com: American Bodybuilding, Fitness and Figure
Getbig Bodybuilding Boards => Steroids Info & Hardcore => Topic started by: reppingfor20 on August 15, 2011, 06:50:28 AM
-
Anyone know were you can get sterile oil to mix with painful stuff, legal too, do you have to filter the sterile oil once you get it? Anybody got any suggestions please let me know.
Here are two places I found that have filtered grapeseed and cottonseed oil. They say filtered, so would I have to do anything to them once I get them before I mix it?
-
No just buy it and cut your painful gear with it. Also you could try baking your gear. Make sure you vent the vial bye putting an 18 gauge needle in the rubber stopper.
-
could a 22gauge needle do or do you need 18 gauge for some reason?
-
No just buy it and cut your painful gear with it. Also you could try baking your gear. Make sure you vent the vial bye putting an 18 gauge needle in the rubber stopper.
also on top of using a 22 g instead of 18 g don't have any on hand if 22g is ok, how long do you bake the cottonseed oil and @ what temp? Also do you just pin the top of the stopper with the needle to create a hole or do you leave the needle in while it's in the oven?
-
Leave the needle in there. It will help vent the bottle! I would set your oven around 300 degrees and let it bake for 20 minutes. Try googling how to bake my gear. You will find exact instructions.
-
Leave the needle in there. It will help vent the bottle! I would set your oven around 300 degrees and let it bake for 20 minutes. Try googling how to bake my gear. You will find exact instructions.
I have asked it in my own thread too..
how to sterilize the oil? bake it by itself or do the conversion and then bake it with the gear?
doesnt BA helps?
-
Leave the needle in there. It will help vent the bottle! I would set your oven around 300 degrees and let it bake for 20 minutes. Try googling how to bake my gear. You will find exact instructions.
ok I just did, they say to bake at 250 degree's for 30 minutes, I will leave needle in there, I hope bottle doesn't blow up lol. Do you leave the needle end in the cottonseed oil itself or above where the small air pouch is?
-
I have asked it in my own thread too..
how to sterilize the oil? bake it by itself or do the conversion and then bake it with the gear?
doesnt BA helps?
bump :-\
-
http://www.researchsupply.net/
-
http://www.researchsupply.net/
In general, is it legal to buy lab equipment to any country?
-
In general, is it legal to buy lab equipment to any country?
fuckin bump im getting pissed here. ;D
Is it legal to order couple vials, oils and filters?
lol
-
not sure, i wouldn't worry though if your order is only a couple vials and stuff, if you are buying hundreds of them then worry.