Getbig.com: American Bodybuilding, Fitness and Figure
Getbig Main Boards => Gossip & Opinions => Topic started by: anabolichalo on April 10, 2013, 01:43:04 PM
-
should you get a 1 ml syringe or 2ml?
and what needle to draw and what to inject?
i'm asking because i think i bought the wrong needles last time, injection needle was too long
-
One inch, 23 gauge. IMO.
If you want buy a single 18 gauge neeedle to pull test out of the multi-use vial. Then switch over to a 23 or 25 for the injection.
-
If you are injecting in your ass cheek, 1 inch is too short....should be 1 1/2". Anywhere else can be 1"....unless you have a lot of fat on your quads. I like 22-23 ga.
-
If you are injecting in your ass cheek, 1 inch is too short....should be 1 1/2". Anywhere else can be 1"....unless you have a lot of fat on your quads. I like 22-23 ga.
no i inject in deltoid and quadricep
-
ive use the 1 inch with 21 gauge to inject in my quads
-
ive use the 1 inch with 21 gauge to inject in my quads
21 in the quad? You're tougher than me. :)
-
i did a shot n asperated and all, did the shot n when i pulled out blood squirted all the way across the room ??? my wife was like wtf just happened
-
One inch, 23 gauge. IMO.
If you want buy a single 18 gauge neeedle to pull test out of the multi-use vial. Then switch over to a 23 or 25 for the injection.
This^^^^^
-
Use 20 gauge needles to draw. 18 gauge tend to tear up the stoppers.
3cc syringe
For injecting, 1 23-25g work great everwhere if you're not 20% bodyfat. 1 1/2 for glutes if you are fat or want to be safe. 5/8 of an inch also works great in delts and even quads if you're not fat.