Getbig.com: American Bodybuilding, Fitness and Figure
Getbig Bodybuilding Boards => Steroids Info & Hardcore => Topic started by: efanhowz on May 17, 2017, 10:07:24 PM
-
how can i avoid clogging the syringe with suspension? brand is alpha pharma and its milky white
im using a regular 3 ml w/ a 31 g 1/2 inch needle. its worked a couple times but im sick of pulling out and pricking again and again
do slin pins clog less?
is there a specific brand of barrels that clog less?
-
how can i avoid clogging the syringe with suspension? brand is alpha pharma and its milky white
im using a regular 3 ml w/ a 31 g 1/2 inch needle. its worked a couple times but im sick of pulling out and pricking again and again
do slin pins clog less?
is there a specific brand of barrels that clog less?
31 gauge is too thin. Go with a 25 gauge. Perfect size IMO. Still pretty much painless.
-
Ive had a couple successful shots through the 31. I might try adding 1 ml of NaCl to dilute it. The amps are 2ml and the few times I could get the whole 2 ml in one spot it was pretty painful.
It's all too much of a pain in the ass anyway. Will give it one more try with added Normal saline
-
Did alpha pharma tren suspension with slin pens no problem, just make sure its in full suspension before shooting it so shake the amp alot first.
-
I run all oils through 29gauge slins haven't had one yet to cause a problem Ide rather sticks 3x with a 29 1cc barrel than do a 25 gauge 3cc barrel personal preference use whatever works your 31g obviously is way to small diameter
-
31 is too small, 29g will work with micronized test s, if not micronized just use a 25g.
-
Idk if the test brands I've used are micronized or not? I've use probably 8'diffetrmt brands over 3 years with slins including some nPp decas tren ace cutmix it all goes out good for me
-
31ga.??? 1/2"????
You need actual "steroid needles". No shorter than 1". 1.5" is better & for suspension you'll probably need a 23ga. 25 will probably get clogged. 21ga is almost a sure thing
-
I use 29s x 1/2 inch is plenty unless you are fat as fuck it's going in the muscle
-
i diluted the 2ml suspension with 2 ml NaCl (normal saline) so i divided the 4ml into two 2ml bilateral shots, 50mg test each
27g no clogging issues
ive never had an injeciton site swollen like this though. pain is mild. will keep you posted on strength
-
Clogging with 27g
Have itchy welts wherever I inject
I give up
This stuff sucks
Just like this board lately
-
draw up an oil based roid first, squirt back out in the bottle, then draw up suspension. the oily barrel will keep the water from sticking
-
I am too hard for thirty ones, they bend.
-
draw up an oil based roid first, squirt back out in the bottle, then draw up suspension. the oily barrel will keep the water from sticking
I have never been pissed off at anything more in my life then these clogged syringes
So.....I MAY give this a try
I was getting some bad side effects from the few successful injections: SUPER itchy injection spots + lumps
So I'm not exactly stoked to try this stuff again