Getbig.com: American Bodybuilding, Fitness and Figure
Getbig Main Boards => Gossip & Opinions => Topic started by: Marty Champions on July 17, 2018, 08:12:46 AM
-
twist 2 of my cross tire irons tryin to get the lugs off, then actually broke one of the lugs on the thread bolt from overtightening, ill just drive with 7 lugs instead of 8. lesson learned u need pro tools for lugs, ive never had an issue before though.
-
Sure.
-
twist 2 of my cross tire irons tryin to get the lugs off, then actually broke one of the lugs on the thread bolt from overtightening, ill just drive with 7 lugs instead of 8. lesson learned u need pro tools for lugs, ive never had an issue before though.
always spray wd40 before you loosen lugs nuts the rods get hot so they self tighten while driving...and when you put the lug nut back on it should be tight enough that you don't have to use all you're strength when you tighten it down it takes a lot to break a tire rod
-
Try penetrating oil and map gas heat on the nut amigo. Also, impact wrenches work so well because shock loads require less torque than steady loads.
-
always spray wd40 before you loosen lugs nuts the rods get hot so they self tighten while driving...and when you put the lug nut back on it should be tight enough that you don't have to use all you're strength when you tighten it down it takes a lot to break a tire rod
i tookk the lugs off on a cold truck but good advice i had my first 5 beers today in almost 2 months in need of a hard reset bro we both have annunaki forheads
-
Try penetrating oil and map gas heat on the nut amigo. Also, impact wrenches work so well because shock loads require less torque than steady loads.
good shit afro american, i tried with my ryobi hammer drill , no bueno
-
;)
-
Normally use a long powerbar and a socket rather than a wheel brace/tyre iron makes it easy, Failing that if you don’t have a rattler flogging the wheel brace with a hammer to shock the nut loose tends to work rather than pulling on it when it’s excessively tight.
The stripped stud should tap out the hub, easy and cheap to replace
-
get yourself an electric impact tool. Always made changing from/to winterwheels a breeze for me since i got it. from 1-2hr job to 10-20 min job.
-
get yourself an electric impact tool. Always made changing from/to winterwheels a breeze for me since i got it. from 1-2hr job to 10-20 min job.
i tried with my ryobi impact baterry dril no bueno
-
Lo mejor en esos casos, es una pistola neumatica de impacto e el ya hablado WD40. Dejalo impregnar una horas antes de intentar con la pistola.
If they are rusted, try a torch to heat them up before. Let it cool.
Sí bueno.
-
Este tipo es una pinche cabron,chupa mis cojones.Me cago en todo lo que se menea, como lee priest!! Puta Madre!!!
-
Este tipo es una pinche cabron,chupa mis cojones.Me cago en todo lo que se menea, como lee priest!! Puta Madre!!!
:D
-
Torque wrench for tightening. $19.99
3/4" socket.
https://www.harborfreight.com/1-2-half-inch-drive-click-type-torque-wrench-62431.html
Breaker bar for loosening. 3/4 socket. $12.99
https://www.harborfreight.com/12-in-drive-25-in-breaker-bar-60819.html