Getbig.com: American Bodybuilding, Fitness and Figure
Getbig Main Boards => Gossip & Opinions => Topic started by: Marty Champions on April 27, 2014, 06:04:21 PM
-
ok asked this blacke guy about the magneto strip on the fly wheel. he says that wasnt my my problem since my mower would start, he said if the magneto strip was the problem then my mower wouldnt start at all
realized it wasnt the muffler either, it seemed to easy plus i could blow air through it so it seemed cleared out
so then i started fucking around with this spring on the armature , i think it was the govener and i notice it would rock/sway causing the engine to lose power and make the rpms go up and down
so i rigged this peice of metal in there to make it almost run wide open and very strong not too strong but definitly strong maybe a tad too much i dont know i didnt over do it i dont think
well anyways i was mowing pretty good got one side of this yard done then the mower slowed down and quit. then i looked at the mower and noticed alot of feul was leaking out of the carbeurater into the air filter. the fuel didnt seem to be leaking out of any lines or the bowl in the carburater.
now how /why can this be never seen this situation before
-
f
-
maybe its the float level "tang" in the float bowl of the carburater is too high causing feul leak, i just read that somewhere maybe i can lower it
-
the carb is dirty, cheap gas. clean the float needle and bowl, take out the jet, clean it etc.. bunch of youtube vids on this shit. buy a can of brakleen and clean that shit up my neegar.
-
the carb is dirty, cheap gas. clean the float needle and bowl, take out the jet, clean it etc.. bunch of youtube vids on this shit. buy a can of brakleen and clean that shit up my neegar.
i buy expensive gas "big" neegar. ive never seen the carb dirty ah fuck ill keep you updated
-
i buy expensive gas "big" neegar. ive never seen the carb dirty ah fuck ill keep you updated
Sometimes the float needle can get permanently stuck and usually you just have to get a new carb. This can even happen to brand new or barely used carbs. The carbs made in China are garbage these days.
-
(http://c.shld.net/rpx/i/s/i/spin/image/spin_prod_813615012?hei=499&wid=499&qlt=50,0&op_sharpen=1&op_usm=0.9,0.5,0,0)
-
"noticed alot of feul was leaking out of the carbeurater into the air filter"
Well it sure as fuk ain`t a spark problem. ;D
-
(http://c.shld.net/rpx/i/s/i/spin/image/spin_prod_813615012?hei=499&wid=499&qlt=50,0&op_sharpen=1&op_usm=0.9,0.5,0,0)
I bought one of those as a backup and I suggest Johnny Falcon/Marty does the same.
You actually get a really close clip and its so satisfying to use. In fact, once you keep it short, just use this to maintain.
-
I buy a cheap mower from Wal-Mart about every 10 years. Usually a 4hp Briggs and Straton. I treat it like a
Whore till mower deck is cracked the fuk.in wheels fall off. $200 for ten years.
-
Jonah Falcon, longest measured penis. A white dude, I'll be damned.
Is this where the name came from?
-
:)
-
This is the best way to mow.
-
-
Jacobs fuel additive and fresh gas...amazing stuff - will make almost anything with a spark and air run.
-
well anyways i was mowing pretty good got one side of this yard done then the mower slowed down and quit. then i looked at the mower and noticed alot of feul was leaking out of the carbeurater into the air filter. the fuel didnt seem to be leaking out of any lines or the bowl in the carburater.
now how /why can this be never seen this situation before
Needle valve must not be sealing because of a piece of dirt or damaged float?
-
maybe its the float level "tang" in the float bowl of the carburater is too high causing feul leak, i just read that somewhere maybe i can lower it
the tang shouldn't be messed up unless you fucked with it before. Needle seat is probably dirty.
-
the tang shouldn't be messed up unless you fucked with it before. Needle seat is probably dirty.
Go see the crossfit thread, I did an entry for u
-
ok gonna mess with the tang needle havent messed with it before. i just wasnt shure if this feul leakage is because i got the governer almost wide open so im getting alot more power
-
ok asked this blacke guy about the magneto strip on the fly wheel. he says that wasnt my my problem since my mower would start, he said if the magneto strip was the problem then my mower wouldnt start at all
realized it wasnt the muffler either, it seemed to easy plus i could blow air through it so it seemed cleared out
so then i started fucking around with this spring on the armature , i think it was the govener and i notice it would rock/sway causing the engine to lose power and make the rpms go up and down
so i rigged this peice of metal in there to make it almost run wide open and very strong not too strong but definitly strong maybe a tad too much i dont know i didnt over do it i dont think
well anyways i was mowing pretty good got one side of this yard done then the mower slowed down and quit. then i looked at the mower and noticed alot of feul was leaking out of the carbeurater into the air filter. the fuel didnt seem to be leaking out of any lines or the bowl in the carburater.
now how /why can this be never seen this situation before
haha. Taking some homies advice over a fellow getbigger. May not be your problem but a motor can start n bog out w a rusted magneto or flywheel. It'll mimick a carb problem.
-
Take $500 to a store and buy a Honda or a Toro. Use it for 10 plus years with zero problems.
-
haha. Taking some homies advice over a fellow getbigger. May not be your problem but a motor can start n bog out w a rusted magneto or flywheel. It'll mimick a carb problem.
i was about to get down to the magneto when i realized the governer seemed to be the issue, but now i got alot of feul leaking like crazy into the air filter, its not coming out of the bowl but the side of the carb in that main area, so hey no ones right thus far. i didnt take his advice over yours man just getting an afro-americans opinion
-
In the future everyone will have round lawns.
-
I bought one of those as a backup and I suggest Johnny Falcon/Marty does the same.
You actually get a really close clip and its so satisfying to use. In fact, once you keep it short, just use this to maintain.
For your bush?
-
i was about to get down to the magneto when i realized the governer seemed to be the issue, but now i got alot of feul leaking like crazy into the air filter, its not coming out of the bowl but the side of the carb in that main area, so hey no ones right thus far. i didnt take his advice over yours man just getting an afro-americans opinion
not laughing at u but this just keeps getting funnier n funnier. If ur not broken agree w everyone else. Get a honda.
-
maybe its the float level "tang" in the float bowl of the carburater is too high causing feul leak, i just read that somewhere maybe i can lower it
Great beverage for all races, Tang / Orange Drank / Jugo de Naranja y Azúcar
(http://www.perfectduluthday.com/wp-content/uploads/2009/07/6a00e5513a3218883301156e875d0e970c-800wi.gif)
-
That's what the argonauts drank.
-
That's what the argonauts drank.
Also an Oscar nominated film.
(http://upload.wikimedia.org/wikipedia/en/4/4b/Pootie_Tang_poster.JPG)
-
I've been down this road with Craftsman lawn equipment and their shoddy attempts to service crap equipment to begin with. Dude, end your misery now and fork over the bucks for a better brand. You'll be better off in the long run.
-
I could fix this mower for you in 20 minutes falcon. :P
-
not laughing at u but this just keeps getting funnier n funnier. If ur not broken agree w everyone else. Get a honda.
I've been down this road with Craftsman lawn equipment and their shoddy attempts to service crap equipment to begin with. Dude, end your misery now and fork over the bucks for a better brand. You'll be better off in the long run.
I’m sorry you are having problems, but I have never had any trouble with anything from Sears.
I can’t help but believe that it is something simple.
-
tweaker
Also: tweeker.
1. Person who constantly stays up cleaning, washing, organizing, powertooling, sorting or otherwise keeping themself busy doing menial tasks.
2. Someone who constantly makes slight alterations on (usually a very specific) object, i.e. computer, software, automobile, etc.
3. A compulsive liar, thief, or both.
4. A methamphetamine ("tweak"), or other form of speed, addict (who displays all of the above in an obsessive-compulsive manner).
-
I’m sorry you are having problems, but I have never had any trouble with anything from Sears.
If you use it for light home use for just you, yes.
But if you've ever put it through a daily workout (i.e. commercial use) a Sears product is jut not going to hold up. This is what the Falcon is learning.
Example. I went through multiple Sears grass trimmers and was constantly bringing them in for service. I finally gave up and bought Echo trimmers. I used them year after year with DAILY commercial use in a landscaping business, and didn't have to do much besides change a spark plug and replace the plastic head cover where the line comes out. (it would get worn down).
I still have one of the Echos from the business and use it at my home. I do jack for maintenance and it runs every season.
-
i got a shindaiwa weedeater that thing is so easy to crank costs 300 but well worth it im willing to spend a little more because im a fucking work horse i just make that shit pay for itself just mow a few extra lawns big fuckin deal but wont be buying another sears mower though just doesnt last for commercial
-
What brand does Getbig recommend in excavators?