Author Topic: 31 gauge with sustanon 250>? (Read 8857 times)

bigjoex · « **on:** July 22, 2007, 08:10:15 PM »

will a 31 gauge needle work with sustanon 250

The Squadfather · « **Reply #1 on:** July 22, 2007, 08:11:42 PM »

hahahahaha, technically yes but you'll be pushing down on that plunger for a half hour trying to push in 1cc.

just get yourself a 21 or 22 suck it up and be a man.

bigjoex · « **Reply #2 on:** July 22, 2007, 08:18:00 PM »

lol i know i went there looking for 22 or 23s the guys like yeah here you go there fucking 31s but im going back tomorrow

The Squadfather · « **Reply #3 on:** July 22, 2007, 08:35:23 PM »

Quote from: bigjoex on July 22, 2007, 08:18:00 PM

lol i know i went there looking for 22 or 23s the guys like yeah here you go there fucking 31s but im going back tomorrow

tell the guy you need them for B12 injections and they'll give you the 22's.

b.c. · « **Reply #4 on:** July 22, 2007, 08:50:56 PM »

You should be fine with 25 gauge as long you shoot 2cc or less. If more than go 23.

trab · « **Reply #5 on:** July 23, 2007, 05:26:27 AM »

I use lots of SUS. I find it a little thicker than most TE TC or Deca.
25ga minimum. 23ga if > 1cc @ a time.

Dont waste it in that small gauge pin.

thewickedtruth · « **Reply #6 on:** July 23, 2007, 05:31:26 AM »

Quote from: bigjoex on July 22, 2007, 08:10:15 PM

will a 31 gauge needle work with sustanon 250

MAN! Needle phobe much?!

krazee · « **Reply #7 on:** July 23, 2007, 06:44:34 AM »

I use 25 guage with no issues, sure it takes an extra 2 minutes...but who cares.

Captain Equipoise · « **Reply #8 on:** July 23, 2007, 08:26:26 AM »

Hope you got till the end of time, trying to push thick oil through a 31g, well that's a lifelong project.
Try a 23

Rimbaud · « **Reply #9 on:** July 23, 2007, 08:46:19 AM »

Quote from: Captain Equipoise on July 23, 2007, 08:26:26 AM

Hope you got till the end of time, trying to push thick oil through a 31g, well that's a lifelong project.
Try a 23

Agreed. Unless you've got the whole weekend to do the shot.

Nicrah · « **Reply #10 on:** July 23, 2007, 08:55:26 AM »

I can't imagine this personally, I tried using a 27 gauge needle for a quad shot once, and i bent it....that sucked so never again will i use anything less than a 25.

DIVISION · « **Reply #11 on:** July 23, 2007, 10:23:33 AM »

Quote from: bigjoex on July 22, 2007, 08:10:15 PM

will a 31 gauge needle work with sustanon 250

You're pushing it, Joseph.

I use a 25G and even that can be a bit rough at times due to scar tissue.

If you are fresh, you might be able to shoot with a 31, but it won't be easy.

Remember, you're pushing oil through that plunger.

It's not water.

DIV

delta9mda · « **Reply #12 on:** July 23, 2007, 10:28:01 AM »

23g,just do it.

jmt1 · « **Reply #13 on:** July 23, 2007, 12:09:31 PM »

lol...i wouldnt even attempt a 31g

25g works fine with the sust....if you heat the loaded syring under some hot water or pop it in the microwave for a few secs it will help the oil flow through the smaller g easier.

trab · « **Reply #14 on:** July 23, 2007, 03:30:00 PM »

Quote from: jmt1 on July 23, 2007, 12:09:31 PM

lol...i wouldnt even attempt a 31g

25g works fine with the sust....if you heat the loaded syring under some hot water or pop it in the microwave for a few secs it will help the oil flow through the smaller g easier.

I dont know if I like the Microwave action on the plastic and medication either, be interesting what FreakFest thinks.

jmt1 · « **Reply #15 on:** July 23, 2007, 06:50:48 PM »

Quote from: trab on July 23, 2007, 03:30:00 PM

I dont know if I like the Microwave action on the plastic and medication either, be interesting what FreakFest thinks.

well only heating it for about 10secs or less doesnt harm the oil or syringe.

first time i read about this was from dan duchaine in his dirty dieting newsletter.

freakfestMD · « **Reply #16 on:** July 24, 2007, 03:48:26 AM »

Quote from: trab on July 23, 2007, 03:30:00 PM

I dont know if I like the Microwave action on the plastic and medication either, be interesting what FreakFest thinks.

Shouldn't be a problem using a little bit of warm water, so long as you don't contaminate the tip of the syringe or the needle. Microwave?? Hmmm..I would be worried more about that one. I am unsure of the effect of a microwave on the drug as well as on the plastic to be honest, but I wouldn't chance it.

I don't know why any of this would be necessary anyway. A 23 guage, 1" pin is the smoothest ride around...

Luv2Hurt · « **Reply #17 on:** July 24, 2007, 04:11:35 AM »

No reason to use the 31 gauge. I can only guess you feel it will hurt less. Get over it, use a needle in the 22-25gauge range. Me like the freak like the 23 G size best.

krazee · « **Reply #18 on:** July 24, 2007, 01:00:48 PM »

23 g for the glutes and 25 for the shoulders, everything in life that is worth doing always hurts a bit....

The Squadfather · « **Reply #19 on:** July 24, 2007, 01:09:41 PM »

maybe i'm a masochist but i ALWAYS used a 21G, sometimes a 19 or 20 on water based stuff.

krazee · « **Reply #20 on:** July 24, 2007, 01:16:02 PM »

Now that is some crazy shit bro, 19 or 20 for water based, shit I draw with an 18 gauge....do you enjoy whips and chains too? LOL

The Squadfather · « **Reply #21 on:** July 24, 2007, 01:20:38 PM »

Quote from: krazee on July 24, 2007, 01:16:02 PM

Now that is some crazy shit bro, 19 or 20 for water based, shit I draw with an 18 gauge....do you enjoy whips and chains too? LOL

hahahahaha, shit's like a dart.

Captain Equipoise · « **Reply #22 on:** July 24, 2007, 01:54:53 PM »

Quote from: The Squadfather on July 24, 2007, 01:20:38 PM

hahahahaha, shit's like a dart.

That's a fucking harpoon... I once bought some 16g (to draw with) and for comedy... the fucking thing is like a pencil in circumference.

krazee · « **Reply #23 on:** July 24, 2007, 03:47:20 PM »

I don't even think I've seen a pin at 16 gauge before to be honest....must be like pulling water through a hose for drawing shit though.

Imagine back in the day, people used to go to Mexico and buy pre-dosed needles...pretty sure I heard the pin was 18 or 16 gauge...insane...

The Squadfather · « **Reply #24 on:** July 24, 2007, 07:31:06 PM »

hahaha, i had a friend who used to jab himself in the shoulder with a 19G with a one and a half inch pin before powerlfting meets with 2cc's of test suspension, crazy mofo.