Please help a new guy out! Thank you

[c3474]

  Well I hope one of you will take to time and give me some good orderly direction, I don't have a clue what I'm doing, I've tried to do my homework but there is so much info out there, I don't even know what my proper dose is ex.. what's the difference between a cc and a ml?? 

  I am a 30 year old 6'0 215 lbs probably 15-18% bodyfat. I have been dieting and lifting off and on for 4 years . I've done both pro-boxing and amateur mma so I know how to cut weight, I fought at 185, what I don't know is how to stack on good lean weight.  I'd like to add 10-15 lbs of lean muscle and shred down to 8-10%. Pretty attainable goals I think.  I have used pro-hormone for years now, I stocked up before they took them off the shelf and finally found a source the other day. My buddy gave me a few shots to get started untill my ship comes in and I haven't been this excited about training in years! Thanks to all you guys who share your knowledge on here I would be totally freaking out if I didn't have a place to turn to get this basic info. 

  Would somebody please help me with frequency and dosage of the gear I have obtained? I don't even know if it's a good stack or not.  I took my first shot of testaplex e250 .40 cc's the other day and I swear I feel it but I dont know if it's psychological or what.  Here's what I have and I have no idea how to take  it.

  10ml/250mg         testaplex e250- testosterone enanthate
  1ml amp/100 mg   primobloan depot ( 2 vials )
  40 tabs               clomid

* My needle are 29 gauge 1/2" 1 cc needles

I'm very confused by what I read on here about when to start on the clomid, thank you in advance to anyone here wo takes the time to respond 

[Big_Tymer]

inject 250mg test on mondays and thursdays. you should get atleast 20ml not 10

2 amps of primo wont do shit, you might as well do them both at the same time with your next test shot

2 weeks after you stop using test, use 100mg per day of clomid for 2 weeks, then use 50mg per day for 2 weeks

and get some 23 or 25 gauge 1 inch pins.  for one you need to do IM injections and it is going to be hard to get there with a 1/2 inch pin, and two it will take you all day to push oil through a 29 gauge pin.

[Arnold jr]

Big Tymer is right on everything.

Question though, you said you have 1ml amps of primo and then you said you ahve two viles...big difference in a vile and amp. An amp is typically one shot while a vile is several shots...how many depends on how much you're taking and how much oil is in the vile.

Also, your other question, ml and cc are the exact same thing...1ml equals 1cc.

[c3474]

Thank both of you so very much, I finally figured out I will have enoguh for 10 shots of test, I still have to figure out what I have on the primo.  Is the clomid ok for post cycle or would you guys recommend something else. That was all that was availible to me at the time.

[Arnold jr]

Thank both of you so very much, I finally figured out I will have enoguh for 10 shots of test, I still have to figure out what I have on the primo.  Is the clomid ok for post cycle or would you guys recommend something else. That was all that was availible to me at the time.

If what you have is enough test for 10 shots, then you're only going to be able to do 1 shot a wk for 10wks...like BT said you really need to get another bottle.

Clomid will be fine

[Big_Tymer]

definitely try to get another vial of test.  250mg for 10 weeks will be better than being natural, but you really should start out at 500mg imo to see more results.  if you wanted to add nolvadex post cycle it wouldnt hurt but its not mandatory.

[DIVISION]

  10ml/250mg         testaplex e250- testosterone enanthate
  1ml amp/100 mg   primobloan depot ( 2 vials )
  40 tabs               clomid

* My needle are 29 gauge 1/2" 1 cc needles

^Sounds like you're using UG.

Why?   

If you can affort Primo, you should be able to afford HG anabolics.

Why are you using insulin needles?   



DIV

[Rimbaud]

^Sounds like you're using UG.

Why?   

If you can affort Primo, you should be able to afford HG anabolics.

Why are you using insulin needles?   



DIV

He's using Axio labs I believe...which is basically UG.

[Hereford]

Insulin needles don't work for oils.

[Rimbaud]

Insulin needles don't work for oils.

I missed that part. Using a slin pin for oils is pretty much useless. However, after a couple days of drawing & a couple days of shooting you'll be good to go. 

[Hereford]

Be a man, c3474

Use 14 gauge needles like the rest of us.

[c3474]

Is it ok to ask for needle sources here? I understand I want 21 or 23 gauge and a 1" pin?? I didnt see any threads on this so I hope its cool, thanks to all who responded.

[c3474]

I'm also confused about UG and HG can someone translate for me? Wow you live and learn. I understand that HG is the preferred gear.

[Big_Tymer]

www.getpinz.com

ug = underground i.e. the dude cooked the gear up on his kitchen stove next to his meth

hg = human grade i.e. made by pharmaceutical companies with govt. regulations for cleanliness and sterility.

[Hereford]

Is it ok to ask for needle sources here? I understand I want 21 or 23 gauge and a 1" pin?? I didnt see any threads on this so I hope its cool, thanks to all who responded.

Some pet stores will have them too.

[DIVISION]

Be a man, c3474.  Use 14 gauge needles like the rest of us.

Speak for yourself, Hereford.

I use 25G for all injections.

Got to be strong to use those.

Some pet stores will have them too.

www.calvetsupply.com



DIV

[Rimbaud]

I personally like calvetsupply over getpinz.

[DIVISION]

I personally like calvetsupply over getpinz.

I found a cheaper place than calvet, but they only sell to medical professionals.

Trying to find a way around it.



DIV