i finally got a hold of my second cycle, but last night when i went to take my first injection of test i saw that all three bottles were frozen. so i let one sit in some warm water for a while--which seemed to work, but when it thawed out it left crystals floating in the oil. i shook it up some, but they wont go away. i tried drawing up 1cc and the crystals gathered at the tip of the needle (can't be good). i've read on a 'frozen aas' thread that crystals are likely a sign of "destabilization" and that the product may no longer be effective. so after reading this i'm afraid that i just injected 1 cc of oil only. if i try to heat the bottle in water in a pot on the stove (below a boiling point) could it re-homogenize? or does this stuff have to go back to the lab? or is it completely useless at this point? any advice would be appreciated