warming gear prior to injecting

[tbombz]

 thin and painless, able to hold higher concentrations of gear without crashing. 

[ghettocentral]

I run my syringe under hot water to just thin the oil out so it goes in smoother.

This quite often.

[Marlo Stanfield]

some oils are thick as fuck... ive had a few different brands on enth where ive had to warm the vials under a warm tap or id be trying to shoot for 5 mins!

ive got a few boxes of cidoteston left that will have to be done the same way when i go back on... oh, and ive been off 5 weeks and im down 21lbs

what gauge syringe were you using?

[RRKore]

I run my syringe under hot water to just thin the oil out so it goes in smoother.

Me, too.  Especially when using 28G slinpins for delt & arm shot.  I just run very hot water over the syringe (w/ cap on needle) while tilting it back and forth until the air bubble moves noticeably faster through the oil.  I guess it takes about 30 - 40 seconds.

[alphaanimal]

i used to when i first started out and had some really crappy test. it was brewed up well above the point of what the solvents could hold and would crash a tiny bit, giving PIP for a few days post injection. heating it and then cutting it with EQ seemed to help a lot.

now, i don't feel the need since nothing i use can't flow through a slin pin.

bro what kind of brewing formula is your guy using please pm me if you know cause a slin pin would be awesome, way less scar tissue.

[alphaanimal]

do you just use same formula to brew but us eol instead of oil??