« previous next »
Pages: [1]   Go Down

Author Topic: Shoulder shot  (Read 1981 times)

ignorance

  • Getbig III
  • ***
  • Posts: 633
  • https://www.facebook.com/ResearchBodybuilding
Shoulder shot
« on: September 24, 2006, 12:55:21 PM »
Shot my left shoulder, in the middle. I know the shot went well, if, a) afterwards it feels like a bruse, b) doesn't hurt at all.  It hurts like a bruse, but now there is a bump under the skin, it has happened before. And it went away. I hurts to do shoulders, and lift anything over my head while standing.

Anything to worry about? or are you all going to reply with this "pussy" ?
Logged

Arnold jr

  • Getbig V
  • *****
  • Posts: 7247
  • fleshandiron.com
Re: Shoulder shot
« Reply #1 on: September 24, 2006, 01:58:40 PM »
I wouldn't worry too much...I've had this happen before...some of the stuff just seeped out under the skin and formed a lump. Try soaking in a hot bath, I mean as hot as you can take it...fill it up with Epsom salt and Alcohol, this should help out.
Logged

dirtyman_209

  • Getbig II
  • **
  • Posts: 173
Re: Shoulder shot
« Reply #2 on: September 24, 2006, 11:31:06 PM »
ive never had it lump in my shoulder but when ever i have lumped up i just massaged the shit out of it to break up the oil pocket
Logged

krazee

  • Getbig III
  • ***
  • Posts: 682
  • It's all about the next shirt size....
Re: Shoulder shot
« Reply #3 on: September 25, 2006, 01:02:47 AM »
Heating pad usually works for me, as well as the massage. Were on your shoulder are you doing the shot?
Logged
Just spot me BITCH!!!

ignorance

  • Getbig III
  • ***
  • Posts: 633
  • https://www.facebook.com/ResearchBodybuilding
Re: Shoulder shot
« Reply #4 on: September 25, 2006, 02:03:31 PM »
the yellow is where the needle went in, and the green is the area of the lump
Logged

udeluz

  • Getbig IV
  • ****
  • Posts: 1339
  • CLICK...CLICK...BOOM !!!!!!!!
Re: Shoulder shot
« Reply #5 on: September 25, 2006, 04:20:29 PM »
Did you go straight in or on a downward angle? What size pin?
Logged
U

ignorance

  • Getbig III
  • ***
  • Posts: 633
  • https://www.facebook.com/ResearchBodybuilding
Re: Shoulder shot
« Reply #6 on: September 25, 2006, 11:00:44 PM »
not being cocky but my shoulders are my best bodypart, and I have a wide base.[not waist] because of this it is hard to hit striaght in, plus the mirror doesnt help.

I injected 500ml of Test E on a almost straight inwards. You know your hand shakes and gets tired of holding up a yourother shoulder and bis.
Size pin : 25g at 1 inch
Fucking oil takes forever to go in.
Logged

Luv2Hurt

  • Competitors II
  • Getbig V
  • *****
  • Posts: 6036
Re: Shoulder shot
« Reply #7 on: September 26, 2006, 04:44:05 AM »
Yeah I dont like to use the 25g because there is too much resistance and it makes for a rough injection because of that.  It can work but pushing so hard on the plunger does cause it to be moved around too much IMO

I use  1" 23g for everything IM
Logged

ignorance

  • Getbig III
  • ***
  • Posts: 633
  • https://www.facebook.com/ResearchBodybuilding
Re: Shoulder shot
« Reply #8 on: September 26, 2006, 10:44:21 AM »
next cycle ill give 23g at 1 inch a try.
Logged

krazee

  • Getbig III
  • ***
  • Posts: 682
  • It's all about the next shirt size....
Re: Shoulder shot
« Reply #9 on: September 26, 2006, 11:17:58 PM »
I take in the juice with a 18 guage, and do the shot with 23 guage as well. especially in the shoulder, probably 22 guage for the glutes.
Logged
Just spot me BITCH!!!

ignorance

  • Getbig III
  • ***
  • Posts: 633
  • https://www.facebook.com/ResearchBodybuilding
Re: Shoulder shot
« Reply #10 on: September 27, 2006, 07:31:25 AM »
I read up on that. changing of the syr. itself.

ex. pin the vial with a 18g and then when you got your amount, you un-screw the syr. and pop on a 23-25g and pin your bodypart. The only problem is not fucking up and spilling the shit all over the floor. Again another experiment for my next cycle which is summer 2007
Logged

Overload

  • Getbig V
  • *****
  • Posts: 7464
  • KO Artist
Re: Shoulder shot
« Reply #11 on: September 27, 2006, 08:23:01 AM »
Quote from: ignorance on September 27, 2006, 07:31:25 AM
I read up on that. changing of the syr. itself.

ex. pin the vial with a 18g and then when you got your amount, you un-screw the syr. and pop on a 23-25g and pin your bodypart. The only problem is not fucking up and spilling the shit all over the floor. Again another experiment for my next cycle which is summer 2007

Huh? it's not hard at all to change needles...

8)
Logged

ignorance

  • Getbig III
  • ***
  • Posts: 633
  • https://www.facebook.com/ResearchBodybuilding
Re: Shoulder shot
« Reply #12 on: September 27, 2006, 08:37:05 AM »
the canadian needles I have are different from american counterparts. Different suppliers
Logged

krazee

  • Getbig III
  • ***
  • Posts: 682
  • It's all about the next shirt size....
Re: Shoulder shot
« Reply #13 on: September 27, 2006, 08:46:44 AM »
Quote from: ignorance on September 27, 2006, 07:31:25 AM
I read up on that. changing of the syr. itself.

ex. pin the vial with a 18g and then when you got your amount, you un-screw the syr. and pop on a 23-25g and pin your bodypart. The only problem is not fucking up and spilling the shit all over the floor. Again another experiment for my next cycle which is summer 2007

Take in a little air at the end and then you won't spill anything. Put the new end on and release the air and bubbles, should be able to do it your first try.
Logged
Just spot me BITCH!!!

Overload

  • Getbig V
  • *****
  • Posts: 7464
  • KO Artist
Re: Shoulder shot
« Reply #14 on: September 27, 2006, 09:13:44 AM »
Quote from: ignorance on September 27, 2006, 08:37:05 AM
the canadian needles I have are different from american counterparts. Different suppliers

what brand?

they are screw type correct?

i've seen many a needle/syringe combos...

8)
Logged

blondmusclhunk

  • Getbig III
  • ***
  • Posts: 638
Re: Shoulder shot
« Reply #15 on: September 27, 2006, 10:06:16 AM »
Ive always used a 23
Logged
Pages: [1]   Go Up
« previous next »