Not boiling/cooking them but peeling the little fuckers. I'm going to look into steamers. I trust TA on these matters. Also, now that I think about it, that's how my mom did it and I don't remember having any probs peeling them. I just didn't know there was a difference between boiling and steaming. I want a steamer that will do at least a half a dozen but a dozen will be ideal.
You don't even need a steamer.
Get 1/2 inch water to boil in a saucepan (yes, measure the water with a ruler) over medium-high heat. As soon as water is boiling, gently place the eggs in the boiling water. I use a slotted spoon usually. Cover saucepan immediately and cook eggs for 6 1/2 minutes to 7 1/2 minutes depending on yolk preference. The lower time will produce a nice creamy, slightly runny center whereas the longer time will produce a more firmly cooked center. Experiment a bit to get it to where you like it. Be sure to measure the time accurately. That way you can duplicate the results over and over and over again without guesswork.
Remove cover, put the saucepan to sink, and place under cold running water for 30 seconds. Remove eggs from pan and peel. They will peel easy and you will not lose a thing. Gently tap the large end against a flat surface, cracking it all over, then gently crack the rest of the egg all over and peel. You should lose nothing.
Also use large eggs that have no cracks and are cold from the refrigerator. Timing is vital to the success of this recipe, so make sure you are timing it. You can use this method for one to six large, extra-large, or jumbo eggs without altering the timing.